LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Stub Axle Shaft Sleeve and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do not damage the seal bore or the sleeve assembly. Fluid leaks may result.
  1. Raise and support the vehicle. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement .
    3. Fig 1: Identifying Stub Axle Shaft Snap Ring
    GM104554Courtesy of GENERAL MOTORS CORP.
  3. Remove the snap ring from the stub axle shaft. Discard the snap ring. Do not reuse.
    4. Fig 2: View Of J 6125-1B & J 38868
    GM104556Courtesy of GENERAL MOTORS CORP.
  4. Remove the stub shaft from the transmission. Use the J 6125-1B  and the J 38868  .
  5. Pull lightly on the shaft. Rotate the shaft until the stub shaft snap ring at the differential seats in the taper on the differential side gear.
  6. Remove inner snap ring.
  7. Remove the right hand axle seal from the transmission. Use the J 23129  and the J 6125-1B  .
scientia non olet · About LEMON Manuals