LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Stub Axle Shaft Sleeve and Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The stub axle shaft sleeve and seal must be replaced together. DO NOT replace the sleeve or seal seperately.
  1. Install the new seal. Use the J 41102-1A  . See Special Tools . Lubricate the seal lip with a light wipe of transmission oil.
    2. Fig 1: Identifying Stub Axle Shaft Snap Ring
    GM104554Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Carefully guide the axle shaft past the lip seal. Do not allow the shaft splines to contact any portion of the seal lip surface, otherwise damage to the seal will occur.
  2. Install the two new snap rings on the stub shaft.
    3. Fig 2: View Of Stub Shaft
    GM104558Courtesy of GENERAL MOTORS CORP.
  3. Install the stub shaft into the transmission. Use a mallet.
  4. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement .
  5. Lower the vehicle.
  6. Inspect the oil level. Refer to Transmission Fluid Checking .
  7. Inspect the shaft and the seal for leaks.
scientia non olet · About LEMON Manuals