LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Output Axle Shaft Sleeve and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the drive axle assembly. Refer to Wheel Drive Shaft Replacement .
    3. Fig 1: Locating Drive Axle Retaining Clip
    GM569164Courtesy of GENERAL MOTORS CORP.
  3. Remove the snap ring from axle.
    4. Fig 2: View Of Case Cover Seal
    GM569151Courtesy of GENERAL MOTORS CORP.
  4. Remove the output axle seal.
    5. Fig 3: Using Special Tool To Remove Sleeve From Output Axle Shaft
    GM569234Courtesy of GENERAL MOTORS CORP.
  5. Use the J 41227  to remove the sleeve from the output axle. See Special Tools .
scientia non olet · About LEMON Manuals