LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Low/Reverse Servo Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Vehicle Lifting Caution .
  1. Raise the vehicle. Support the vehicle.
  2. Remove the oil pan and filter. Refer to Automatic Transmission Fluid Filter and Seal Replacement .
  3. Remove the oil feed pipes. Refer to Oil Feed Pipes Replacement .
    4. Fig 1: View Of Low/Reverse Servo Assembly
    GM588858Courtesy of GENERAL MOTORS CORP.
  4. Remove the three low/reverse band servo cover bolts, the servo and the spring.
  5. Disassemble, clean and inspect the low/reverse servo assembly. Refer to Low and Reverse Servo Disassemble  in Automatic Transmission Transaxle Unit Repair Manual.
scientia non olet · About LEMON Manuals