LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Case Side Cover Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying J 41102
    GM569238Courtesy of GENERAL MOTORS CORP.
  1. Use the J 41102-1A  and a mallet in order to install the new case cover seal. See Special Tools .
    2. Fig 2: View Of J 41228
    GM569243Courtesy of GENERAL MOTORS CORP.
  2. Use the J 41228  in order to install a new sleeve on the output axle. Install the J 41228  so that the collar is in the snap ring groove.
    3. Fig 3: Locating Drive Axle Retaining Clip
    GM569164Courtesy of GENERAL MOTORS CORP.
  3. Install the axle shaft retaining clip onto the output axle.
  4. Install the drive axle assembly. Refer to Wheel Drive Shaft Replacement .
  5. Lower the vehicle.
  6. Inspect the shaft sleeve for leaks.
  7. Inspect the transmission oil level. Refer to Transmission Fluid Checking .
scientia non olet · About LEMON Manuals