LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Case Side Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transmission Side Cover Bolts
    GM510427Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission side cover.
    2. NOTE: Refer to Fastener Notice .
  2. Hand start the transmission side cover lower bolts.

    Tighten:  Tighten the side cover bolts and stud to 20 N.m (15 lb ft).

  3. Lower the vehicle.
  4. Raise the engine with the engine support fixture.
  5. Raise the vehicle.
  6. Install the transmission mount. Refer to Transmission Front Mount Replacement  or Transmission Rear Mount Replacement .
  7. Install the frame. Refer to Frame Replacement .
  8. Install the power steering gear mounting bolts. Refer to Power Steering Gear Replacement .
  9. Install the wheel drive shaft to the transmission. Refer to Wheel Drive Shaft Replacement .
  10. Connect the left ball joint to the steering knuckle. Refer to Lower Ball Joint Replacement (with FE1 Only) .
  11. Install the left inner fender liner. Refer to Front Fender Liner Replacement .
  12. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  13. Lower the vehicle.
  14. Remove the engine support fixture. Refer to Engine Support Fixture .
    15. Fig 2: Locating Transaxle Range Switch Bolts
    GM893832Courtesy of GENERAL MOTORS CORP.
  15. Install the PNP switch. Refer to Park/Neutral Position Switch Replacement .
    16. Fig 3: Removing/Installing Transaxle Range Switch Lever & Nut
    GM893829Courtesy of GENERAL MOTORS CORP.
  16. Install the PNP switch lever and nut.

    Tighten:  Tighten the nut to 35 N.m (26 lb ft).

    17. Fig 4: View Of Shift Cable & Shift Linkage
    GM494775Courtesy of GENERAL MOTORS CORP.
  17. Install the shift cable bracket.
  18. Connect the shift cable from the PNP switch.
    19. Fig 5: View Of Junction Block
    GM736049Courtesy of GENERAL MOTORS CORP.
  19. Install the underhood electrical center bracket.
  20. Install the underhood electrical center to the bracket.
    21. Fig 6: Identifying Air Cleaner Assembly
    GM13340Courtesy of GENERAL MOTORS CORP.
  21. Install the air cleaner housing assembly. Refer to Air Cleaner Assembly Replacement .
  22. Fill the transmission. Refer to Transmission Fluid Checking and Fluid Capacity Specifications .
scientia non olet · About LEMON Manuals