LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Oil Cooler Pipes Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Transaxle Oil Cooler Pipe
    GM1523656Courtesy of GENERAL MOTORS CORP.
  1. Install the transaxle oil cooler pipes to the vehicle.
  2. Install the transaxle oil cooler pipes to the fittings at the radiator.
  3. Install the transaxle oil cooler pipe to the retaining clip at the radiator.
    4. Fig 2: View Of Transaxle Oil Cooler Pipes
    GM1523657Courtesy of GENERAL MOTORS CORP.
  4. Install the transaxle oil cooler pipes to the transaxle.
    5. NOTE: Refer to Fastener Notice .
  5. Install the transaxle oil cooler pipe retaining nut.

    Tighten:  Tighten the nut to 7 N.m (62 lb in).

  6. Remove the drain pan.
  7. Lower the vehicle.
    8. NOTE: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  8. Adjust the transmission fluid level. Refer to Transmission Fluid Checking .
  9. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals