LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Shift Control Mechanism
    GM1663966Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control (3) to the vehicle.
  2. Connect the shift lock solenoid harness connector (4).
    3. NOTE: Refer to Fastener Notice .
  3. Install the shift control nuts (2).

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

    4. Fig 2: View Of Shift Control
    GM851244Courtesy of GENERAL MOTORS CORP.
  4. Connect the shift cable to the shift control assembly.
  5. Install the console trim plate. Refer to Console Front Trim Plate Replacement .
scientia non olet · About LEMON Manuals