LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Spacer Plate and Gaskets Installation

Spacer Plate and Gaskets Installation

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Driver Shift Control Plate
    GM768697Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The non-Driver Shift Control (DSC) 4T40-E/4T45-E has a different spacer plate than the 4T45-E Driver Shift Control (DSC). The DSC spacer plate has one notch on it. The NON-DSC spacer plate has two notches on it.
  1. Inspect the spacer plate for damage.
  2. If damaged, replace the spacer plate (23).
    3. Fig 2: View Of Spacer Plate To Channel Plate Gasket
    GM768695Courtesy of GENERAL MOTORS CORP.
  3. Install a new spacer plate to channel plate gasket (24) onto the channel plate.
  4. Install the spacer plate (23) on top of the gasket and channel plate.
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the spacer plate support (21) and the two bolts (20) onto the spacer plate. Hand start the bolts.

    Tighten:  Tighten the bolts to 14 N.m (10.5 lb ft).

scientia non olet · About LEMON Manuals