LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Output Shaft Installation

Output Shaft Installation

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Output Shaft And Snap RIng
    GM474281Courtesy of GENERAL MOTORS CORP.
  1. Install a new snap ring (57) into the snap ring groove on the final drive end (small machined diameter) of the output shaft (94).
  2. Install the output shaft (94) into the final drive assembly. Use a mallet in order to install the shaft (94) through the final drive differential gear.
    3. Fig 2: View Of Snap Ring And Output Shaft Snap Ring Groove
    GM474279Courtesy of GENERAL MOTORS CORP.
  3. Install a new snap ring (57) into the output shaft snap ring groove.
scientia non olet · About LEMON Manuals