LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Oil Pump Assembly Installation

Oil Pump Assembly Installation

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Oil Pump Shaft & Oil Pump Assembly
    GM1205806Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump shaft (19) into the oil pump assembly (10).
  2. Install the oil pump assembly (10) and the oil pump shaft (19) onto the control valve body.
    3. Fig 2: Identifying Oil Pump Bolts
    GM1205827Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the eight oil pump bolts (8, 9, 12). Hand start the bolts.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals