LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Drive, Driven Sprockets and Drive Link Assemble

Drive, Driven Sprockets and Drive Link Assemble

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

    Fig 1: Exploded View Of Drive Sprocket & Snap Rings
    GM20874Courtesy of GENERAL MOTORS CORP.
  1. Assemble the drive sprocket (37) onto the turbine shaft (39).
  2. Retain the drive sprocket with the turbine shaft to drive sprocket snap ring (35).
    3. Fig 2: Installing Seals On Turbine Shaft
    GM20314Courtesy of GENERAL MOTORS CORP.
  3. In order to assemble three new Teflon seals (33, 40) onto the turbine shaft (39), perform the following procedure:
    1. Slide the J 29569-1  over the large spline of the turbine shaft. See Special Tools .
    2. Coat the J 29569-1  with transmission fluid. See Special Tools .
    3. Use your fingers in order to guide the new Teflon™ seals over the J 29569-1  and into the seal ring grooves on the turbine shaft. See Special Tools .
    4. Remove the J 29569-1  when the seals are in place. See Special Tools .
      5. IMPORTANT: In order to properly size the seals, keep the J 29569-2  in place for 5 minutes. See Special Tools .
    5. Size the new Teflon™ seals. Use both halves of the J 29569-2  . See Special Tools .
    6. Repeat steps 3.1 through 3.6 with J 29829-1  and J 29829-2  on the small splined side of the turbine shaft. See Special Tools .
scientia non olet · About LEMON Manuals