LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 685 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Drive Sprocket Support Installation

Drive Sprocket Support Installation

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inspecting Converter Seal Drain Holes For Blockage
    GM25500Courtesy of GENERAL MOTORS CORP.
  1. Inspect the drive sprocket support (43) for damage to the stator shaft splines, the journals, the bushings, and the roller bearing.
  2. Inspect the converter seal drain holes for blockage.
    3. Fig 2: Locating Drive Sprocket Support
    GM20213Courtesy of GENERAL MOTORS CORP.
  3. Install the drive sprocket support (43) into the bell housing of the transmission case.
  4. Install the six drive sprocket support bolts (53) into the drive sprocket support (43).
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Hand start the bolts.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals