LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  3. Remove the left front fender liner. Refer to Front Fender Liner Replacement .
  4. Remove the left front splash shield-engine. Refer to Splash Shield Replacement - Engine .
    5. Fig 1: View Of MAF Sensor
    GM1386444Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the mass air flow (MAF) sensor.
  6. Remove the 2 fasteners.
  7. Remove the MAF sensor from the air cleaner housing.
scientia non olet · About LEMON Manuals