LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAF Sensor
    GM1386444Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF sensor into the air cleaner housing.
    2. NOTE: Refer to Fastener Notice .
  2. Secure the MAF sensor to the air cleaner housing with the 2 fasteners.

    Tighten:  Tighten the 2 fasteners to 2 N.m (18 lb in).

  3. Connect the MAF sensor electrical connector.
  4. Install the left front splash shield-engine. Refer to Splash Shield Replacement - Engine .
  5. Install the left front fender liner. Refer to Front Fender Liner Replacement .
  6. Install the left front tire and wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) or Tire and Wheel Removal and Installation (5 Lug Wheel) .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals