LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement (TMAP) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating TMAP Sensor
    GM1382191Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the temperature manifold absolute pressure (TMAP) sensor harness connector.
  2. Remove the TMAP sensor from the intake manifold.
    3. IMPORTANT: If the TMAP sensor seal is damaged, the TMAP sensor must be replaced.
  3. Inspect the seal for damage.
scientia non olet · About LEMON Manuals