LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View OF Ignition Coils
    GM1387190Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Make sure that the ignition coil seals are properly seated to the valve cover.
  1. Install the ignition coil.
    2. NOTE: Refer to Fastener Notice .
  2. Install the ignition coil retaining bolts.

    Tighten:  Tighten the ignition coil retaining bolts to 10 N.m (89 lb in).

  3. Replace the ignition coil connectors.
scientia non olet · About LEMON Manuals