LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank Vent Line Quick Connect Fitting
    GM1656960Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps or plugs from the fuel tank opening and vent line.
  2. Install the fuel fill hose to the fuel tank. Align the "D" notch on the fill hose (1) with the "D" notch on the fuel tank (1).
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the fuel fill hose clamp (3) at the fuel tank.

    Tighten:  Tighten the clamp to 4.5 N.m (40 lb in).

  4. Connect the fuel tank vent line quick connect fitting (2) to the fill pipe recirculation line. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 2: View Of Fuel Fill Pipe Lower Bolt
    GM1656988Courtesy of GENERAL MOTORS CORP.
  5. Install the fuel fill pipe lower bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    6. Fig 3: View Of Fuel Tank Evaporative Emission Line Quick Connect Fittings
    GM1656958Courtesy of GENERAL MOTORS CORP.
  6. Remove the cap or plug from the EVAP canister fitting.
  7. Connect the fuel fill vent pipe quick connect fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Lower the vehicle.
  9. Install the fuel fill pocket. Refer to Fuel Tank Filler Pipe Housing Replacement .
  10. Refill the fuel tank.
scientia non olet · About LEMON Manuals