LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine/Chassis >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Purge Pipe
    GM879155Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the evaporative emission (EVAP) purge pipe from the engine purge hose. Refer to Plastic Collar Quick Connect Fitting Service .
  2. Cap or plug the purge pipe and the engine purge hose to prevent contamination.
    3. Fig 2: View Of Rear Brake Pipe Bracket Retaining Nut
    GM890000Courtesy of GENERAL MOTORS CORP.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the EVAP canister for pipe removal access. Refer to Evaporative Emission Canister Replacement .
  5. Remove the rear brake pipe bracket retaining nuts and release the brackets from the body studs.
    6. Fig 3: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
  6. Release the pipe retainers (1) from the vehicle underbody.
  7. Remove the purge pipe from the pipe retainers.
  8. Lower the rear of the pipe while moving the pipe rearward slightly, then lower the front of the pipe.
  9. Remove the purge pipe from the vehicle.
scientia non olet · About LEMON Manuals