LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine/Chassis >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
  1. Position the purge pipe to the vehicle.
  2. With the rear of the pipe positioned slightly rearward and down, raise the front of the pipe into position.
  3. Install the remainder of the pipe into position.
  4. Install the purge pipe to the pipe retainers.
  5. Secure the pipe retainers (1) to the vehicle underbody.
    6. Fig 2: View Of Rear Brake Pipe Bracket Retaining Nut
    GM890000Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Install the rear brake hose brackets to the body studs and install the rear brake hose bracket retaining nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  7. Install the EVAP canister. Refer to Evaporative Emission Canister Replacement .
  8. Lower the vehicle.
    9. Fig 3: View Of EVAP Purge Pipe
    GM879155Courtesy of GENERAL MOTORS CORP.
  9. Remove the caps or plugs from the purge pipe and the engine purge hose.
  10. Connect the purge pipe to the engine purge hose. Refer to Plastic Collar Quick Connect Fitting Service .
scientia non olet · About LEMON Manuals