LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP canister purge valve on to the purge bracket.
    2. Fig 1: View Of EVAP Canister Purge Valve
    GM1387197Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the EVAP canister purge valve and bracket.

    Tighten:  Tighten the purge bracket nut to 8 N.m (71 lb in).

  3. Connect the purge pipe to the EVAP canister purge valve.
  4. Connect the vacuum pipe to the EVAP canister purge valve.
  5. Connect the EVAP canister purge valve harness connector.
scientia non olet · About LEMON Manuals