LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
    Fig 1: Locating ECT Sensor, Boost Control Solenoid, & IAT Sensor
    GM1389396Courtesy of GENERAL MOTORS CORP.
  1. Turn OFF the ignition.
  2. Drain the coolant system to below the engine coolant temperature (ECT) sensor. Refer to Draining and Filling Cooling System (2.0L (LSJ)) or Draining and Filling Cooling System (GE 47716 Fill) .
  3. Disconnect the engine coolant temperature ECT sensor electrical connector.
  4. Carefully remove the ECT sensor (1).
scientia non olet · About LEMON Manuals