LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Position Sensor Housing
    GM1534962Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the drive belt tensioner. Refer to Drive Belt Tensioner Replacement - Supercharger .
  3. Remove the underhood junction block. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
  4. Disconnect the electrical connector from the camshaft position (CMP) sensor.
  5. Remove the CMP sensor studs.
  6. Remove the CMP sensor.
scientia non olet · About LEMON Manuals