LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Controls And Fuel - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Cleaner
    GM1386447Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Verify full engagement of the inlet onto the resonator neck.
  1. Position the air cleaner assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Install the air cleaner assembly attachment bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Air Intake Duct
    GM1386445Courtesy of GENERAL MOTORS CORP.
  3. Connect the air cleaner resonator to the air cleaner assembly.

    Tighten:  Tighten the air cleaner outlet duct clamps to 5 N.m (44 lb in).

scientia non olet · About LEMON Manuals