Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Ignition Coils

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the ignition coil(s).
Install the ignition coil bolt(s).
Tighten: Tighten the bolt(s) to 10 N.m (89 lb in).

Fig 2: Identifying Camshaft Position Actuator Solenoid Valve Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the ignition coil electrical connector(s) (1).
Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .