LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Engine Controls And Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the fuel pump is OFF.
    2. Fig 1: View Of Fuel System Pressure Tester
    GM854376Courtesy of GENERAL MOTORS CORP.
  2. Place the bleed hose of the SA9127E  , or the J 34730-1A  into an approved fuel container. See Special Tools .
  3. Open the bleed valve on the SA9127E  , or the J 34730-1A  in order to bleed the fuel system pressure. See Special Tools .
  4. Place a shop towel under the fuel pressure service connection to catch any remaining fuel spillage.
  5. Remove the SA9127E  , or the J 34730-1A  from the fuel pressure service connection. See Special Tools .
  6. Drain any fuel remaining in the SA9127E  , or the J 34730-1A  into an approved fuel container. See Special Tools .
  7. Inspect for leaks using the following procedure:
    1. Turn the ignition ON, with the engine OFF for 2 seconds.
    2. Turn the ignition OFF for 10 seconds.
    3. Turn the ignition ON, with the engine OFF for 2 seconds.
    4. Turn the ignition OFF.
    5. Inspect for leaks.
  8. Install the cap on the fuel pressure service connection.
  9. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals