LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Engine Controls And Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Engine/Chassis >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
  1. Position the EVAP purge line to the vehicle.
  2. With the rear of the line positioned slightly rearward and down, raise the front of the line into position.
  3. Install the remainder of the line into position.
  4. Install the EVAP purge line to the pipe retainers.
  5. Secure the pipe retainers (1) to the vehicle underbody.
    6. Fig 2: View Of Rear Brake Pipe Bracket Retaining Nut
    GM890000Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Install the rear brake hose brackets to the body studs and install the rear brake hose bracket nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  7. Install the EVAP canister. Refer to Evaporative Emission Canister Replacement .
  8. Lower the vehicle.
    9. Fig 3: Identifying Chassis EVAP Vapor Line
    GM1652164Courtesy of GENERAL MOTORS CORP.
  9. Remove the caps or plugs from the EVAP line and the purge solenoid.
  10. Connect the EVAP line to the EVAP purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
  11. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals