LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Engine Controls And Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Position (CKP) Sensor Wiring Harness Electrical Connector And CKP Sensor
    GM1656996Courtesy of GENERAL MOTORS CORP.
  1. Remove the starter. Refer to Starter Motor Replacement (RPO LSJ) or Starter Motor Replacement (RPOs L61/LE5) .
  2. Disconnect the crankshaft position (CKP) sensor wiring harness electrical connector from the CKP sensor.
    3. Fig 2: Identifying CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor.
scientia non olet · About LEMON Manuals