LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Engine Controls And Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAF/IAT Sensor Engine Harness Electrical Connector
    GM1647998Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
    3. Fig 2: Identifying Air Cleaner Assembly
    GM1652246Courtesy of GENERAL MOTORS CORP.
  3. Release the air cleaner latches.
  4. Separate the upper and lower portions of the air cleaner assembly.
  5. Remove the air cleaner filter from the lower air cleaner housing.
  6. Inspect the air cleaner filter for dust, dirt, and water contamination.
scientia non olet · About LEMON Manuals