LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Engine Controls And Fuel - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying APP Sensor
    GM1633085Courtesy of GENERAL MOTORS CORP.
  1. Position the accelerator pedal with sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the accelerator pedal bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: Identifying Steering Column Filler Panel
    GM1651113Courtesy of GENERAL MOTORS CORP.
  3. Connect the I/P wiring harness electrical connector to the APP sensor.
  4. Install the steering column filler panel. Refer to Steering Column Opening Filler Replacement .
scientia non olet · About LEMON Manuals