LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Secondary Air Injection Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Harness Electrical Connector
    GM1652362Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine harness electrical connector from the secondary air injection (AIR) pump.
    3. Fig 2: Identifying AIR Pump
    GM1652377Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the AIR pump inlet hose quick connect fitting at the AIR pump. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Reposition the hose out of the way.
    5. Fig 3: Identifying Air Outlet Hose/Pipe Bracket To/From Heat Shield Stud
    GM1650781Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the AIR pump outlet hose quick connect fitting at the AIR pump. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Reposition the hose out of the way.
    7. Fig 4: View Of AIR Pump
    GM1652371Courtesy of GENERAL MOTORS CORP.
  7. Remove the AIR pump bolts.
  8. Remove the AIR pump.
scientia non olet · About LEMON Manuals