LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Secondary Air Injection Pump Inlet Hose/Duct Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying AIR Pump
    GM1652377Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the secondary air injection (AIR) pump inlet hose quick connect fitting at the AIR pump. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Lower the vehicle.
    4. Fig 2: Identifying AIR Pump Inlet Hose
    GM1652374Courtesy of GENERAL MOTORS CORP.
  4. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement .
  5. Disconnect the AIR pump inlet hose quick connect fitting from the air cleaner. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Remove the AIR pump inlet hose.
scientia non olet · About LEMON Manuals