LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of MAF/IAT Sensor
    GM1656943Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the MAF/IAT sensor screws.

    Tighten:  Tighten the screws to 0.6 N.m (5 lb in).

    3. Fig 2: View Of MAF/IAT Sensor Engine Harness Electrical Connector
    GM1647998Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine harness electrical connector to the MAF/IAT sensor.
scientia non olet · About LEMON Manuals