LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the starter. Refer to Starter Motor Replacement (RPO LSJ) or Starter Motor Replacement (RPOs L61/LE5) .
    2. Fig 1: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the knock sensor (KS) harness connector.
  3. Remove the KS retaining bolt.
  4. Remove the KS.
scientia non olet · About LEMON Manuals