LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Vent Solenoid Valve Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
  2. Disconnect the evaporative emission (EVAP) canister harness electrical connector (1) from the fuel tank pressure sensor.
    3. Fig 2: View Of Fuel Tank Pressure Sensor To EVAP Canister
    GM1742792Courtesy of GENERAL MOTORS CORP.
  3. Using a small flat bladed screwdriver, carefully lift and release the fuel tank pressure sensor from the EVAP canister.
scientia non olet · About LEMON Manuals