Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Align the fuel pump tab with the opening in the fuel pump module. Guide the fuel pump filter into the fuel pump module.
- Install the fuel pump to the fuel pump module.
- Rotate the fuel pump to the right until the tab (1) is locked into the fuel pump module.
- Position the fuel pump line.
- Install the fuel pump quick connect fitting (3) to the fuel filter. Refer to Plastic Collar Quick Connect Fitting Service .
- Position a NEW fuel pump flange seal (3) onto the fuel tank.
- If required, install the lock ring onto the flange. Position the fuel pump flange (2) and lock ring (1) over the fuel tank opening.
- Ensure that the fuel pump flange tab is aligned with the arrow on the fuel tank.
- Connect the fuel tank vent valve and the fuel filter quick connect fittings (1) to the fuel pump flange. Refer to Plastic Collar Quick Connect Fitting Service .
- Connect the fuel level sensor electrical connector to the fuel pump flange.
- Slowly lower the fuel pump flange into the fuel tank.
- Using the J 39765 , lock the fuel sender lock ring.
- Install the fuel tank. Refer to Fuel Tank Replacement (RPO NT7) or Fuel Tank Replacement (RPO NU6) .