LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Injector Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel rail. Refer to Fuel Rail Assembly Replacement .
    2. Fig 1: Fuel Rail Assembly Component View
    GM854298Courtesy of GENERAL MOTORS CORP.
  2. Remove the fuel injector retainer clip (3).
  3. Remove the fuel injectors (5) from the fuel rail.
    4. IMPORTANT: Visually inspect the fuel injector in order to determine if the upper O-ring was also removed. If the upper O-ring is not removed, remove the O-ring from the fuel rail assembly.
  4. Remove and discard the fuel injector O-rings (4, 7).
scientia non olet · About LEMON Manuals