LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EVAP Canister Retaining Bolt
    GM1652165Courtesy of GENERAL MOTORS CORP.
  1. Insert the retaining tab on the EVAP canister into the slotted bracket on the vehicle underbody.
    2. NOTE: Refer to Fastener Notice .
  2. Install the EVAP canister bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Fuel Fill Vent Pipe Quick Connect Fitting
    GM1651435Courtesy of GENERAL MOTORS CORP.
  3. Connect the fuel tank EVAP line quick connect fittings (1, 3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  4. Connect the fuel fill vent pipe quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: View Of EVAP Canister Vent Solenoid Valve Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP canister harness electrical connector (1) to the fuel tank pressure sensor.
  6. Connect the EVAP canister harness electrical connector (2) to the EVAP canister vent solenoid valve.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals