LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EVAP Canister Purge Valve
    GM1578478Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister purge valve to the bracket.
  2. Position the EVAP canister purge valve with bracket to the cylinder head.
    3. NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister purge valve bracket bolt.

    Tighten:  Tighten the bolt to 18 N.m (13 lb ft).

    4. Fig 2: Identifying Chassis EVAP Vapor Line
    GM1652164Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis EVAP vapor line to the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    5. Fig 3: Identifying EVAP Canister Purge Valve Tube
    GM1623766Courtesy of GENERAL MOTORS CORP.
  5. Connect the chassis EVAP vapor line to the EVAP canister purge valve. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 4: Locating EVAP Purge Solenoid Electrical Connector
    GM1647981Courtesy of GENERAL MOTORS CORP.
  6. Connect the engine harness electrical connector (2) to the EVAP canister purge valve.
  7. Install the engine harness retainer (1) to the EVAP canister purge valve bracket.
  8. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals