Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air outlet resonator to the throttle body.
- Connect the fresh air duct to the air outlet resonator.
- Tighten the air outlet resonator to throttle body clamp.
Tighten: Tighten the clamp to 5 N.m (44 lb in).
- Align the air outlet resonator to the bracket and install the push-pin fastener.
- Connect the air cleaner assembly fresh air duct to the air outlet resonator.
Tighten: Tighten the clamp to 5 N.m (44 lb in).
- Connect the IAT sensor harness connector.
NOTE:
Refer to Fastener Notice
.