LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of IAT Sensor Harness Connector
    GM851290Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the intake air temperature (IAT) sensor harness connector.
  2. Loosen the air cleaner assembly clamp.
    3. Fig 2: Exploded View Of Air Cleaner Filter
    GM851250Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the air cleaner assembly clips.
  4. Remove the upper air cleaner cover.
  5. Remove the air cleaner filter from the lower air cleaner housing.
  6. Inspect the air cleaner filter for dust, dirt, and water contamination.
  7. Replace as necessary. Refer to Maintenance Schedule (North American Emissions) .
scientia non olet · About LEMON Manuals