Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the clutch line (2) to the clutch master cylinder and the transaxle.
- Connect the clutch hose (1) to the clutch actuator cylinder and the brake master cylinder reservoir.
- Remove the shop towel and discard in a suitable container.
- Install the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
- Fill the brake/clutch reservoir with DOT 3 hydraulic fluid to the proper fluid level.
- Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding .
IMPORTANT:
Ensure that the clutch line locks securely in place.