Removal Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Remove the steering column. Refer to STEERING COLUMN REPLACEMENT .

Fig 1: View Of Clutch Start Switch

Courtesy of GENERAL MOTORS CORP.

Remove the clutch start switch (2) from the clutch pedal bracket.

Fig 2: View Of Clutch Pedal Pivot Nut

Courtesy of GENERAL MOTORS CORP.

Remove the clutch pedal pivot nut.

Fig 3: View Of Clutch Pedal & Bracket Assembly

Courtesy of GENERAL MOTORS CORP.

Remove the clutch pedal bracket to front of dash nuts.
Disconnect the electrical connector from the clutch pedal position (CPP) switch.

Fig 4: Clutch Master Cylinder Pushrod Retainer Tabs

Courtesy of GENERAL MOTORS CORP.

Depress the tabs of the clutch master cylinder pushrod retainer and release the clutch pedal from the pushrod.
Remove the clutch pedal assembly from the vehicle.
If replacing the clutch pedal, remove the CPP switch from the clutch pedal assembly. Refer to Clutch Pedal Position Switch Replacement .