LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 678 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Position Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. A 3/32 inch or 2mm drill bit can be used as a gauge tool for the proper adjustment of the CPP switch. Insert and seat the 3/32 inch or 2 mm drill bit through the slot in the top of the clutch pedal assembly.
    2. Fig 1: View Of Clutch Pedal Position Switch
    GM889965Courtesy of GENERAL MOTORS CORP.
  2. Install the CPP switch (1) to the clutch pedal assembly.
  3. While holding the pedal in the fully released position, press the switch (1) toward the pedal until the barrel of the switch touches the drill bit on the pedal assembly.
  4. Rotate the switch (1) clockwise to secure.
  5. Remove the drill bit.
  6. Connect the electrical connector (2) to the CPP switch (1).
  7. Install the clutch pedal assembly. Refer to Clutch Pedal Replacement .


    Fig 1: Removing/Installing CPP Switch From/To Clutch Pedal
    GM1547861Courtesy of GENERAL MOTORS CORP.
  1. A 3/32 inch or 2 mm drill bit can be used as a gage tool for the proper adjustment of the CPP switch. Insert and seat the 3/32 inch or 2 mm drill bit through the slot in the top of the clutch pedal assembly.
  2. Install the CPP switch (1) to the clutch pedal assembly.
  3. While holding the pedal in the fully released position, press the switch (1) toward the pedal until the barrel of the switch touches the drill bit on the pedal assembly.
  4. Rotate the switch (1) clockwise to secure.
  5. Remove the drill bit.
  6. Connect the electrical connector (2) to the CPP switch (1).
scientia non olet · About LEMON Manuals