LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 678 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Master Cylinder Replacement (MU3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Clutch Master Cylinder
    GM1549851Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: While installing, ensure that the clutch master cylinder pushrod is aligned with he clutch pedal.
  1. Install the clutch master cylinder while rotating 1/4 turn counterclockwise.
  2. Uncap the reservoir and hydraulic lines.
    3. Fig 2: Clutch Hose
    GM1549845Courtesy of GENERAL MOTORS CORP.
  3. Connect the clutch line (2) to the clutch master cylinder.
  4. Connect the clutch hose (1) to the clutch master cylinder.
  5. Install the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
  6. Connect the clutch master cylinder pushrod to the clutch pedal.
  7. Install the clutch pedal retainer.
  8. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding .
scientia non olet · About LEMON Manuals