LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 678 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Drive Plate and Clutch Driven Plate (M86) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Clutch Cover And Clutch Disc
    GM100733Courtesy of GENERAL MOTORS CORP.
  1. Align the machined side of the flywheel assembly, with the machined side of the cover.
    2. Fig 2: View Of J 43482 Supporting The Clutch Cover
    GM892789Courtesy of GENERAL MOTORS CORP.
  2. Install the J 43482  in order to support the clutch cover to the flywheel assembly. See Special Tools .
    3. Fig 3: Clutch Cover-To-Flywheel Bolt Installation Sequence
    GM100744Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the clutch cover to flywheel bolts.

    Tighten:  Follow the tightening sequence. Tighten the bolts to 24 N.m (18 lb ft).

  4. Remove the J 43482  . See Special Tools .
    5. IMPORTANT: Excessive amounts of lubricant on the input shaft splines may contaminate the clutch disc and cause clutch shudder.
  5. Lubricate the inside diameter of the bearing with Saturn P/N 21005995, or equivalent.
  6. Install the transmission. Refer to Transmission Replacement for the - M86/M94 Getrag transaxle.
  7. Bleed the hydraulic system. Refer to Hydraulic Clutch Bleeding .
  8. Connect the negative battery cable.
scientia non olet · About LEMON Manuals