LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Upper Intake Manifold Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Upper Intake Manifold Sight Shield
    GM1657261Courtesy of GENERAL MOTORS CORP.
  1. Install the intake manifold sight shield.
    2. NOTE: Refer to Fastener Notice .
  2. Install the intake manifold sight shield screws.

    Tighten:  Tighten the screws to 9 N.m (80 lb in).

scientia non olet · About LEMON Manuals