LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Supercharger Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. Refer to Drive Belt Replacement .
    2. Fig 1: View Of EVAP Tube & Valve
    GM1381507Courtesy of GENERAL MOTORS CORP.
  2. Remove the evaporative emission (EVAP) tube and EVAP valve.
    3. Fig 2: View Of Throttle Body & Gasket
    GM1339289Courtesy of GENERAL MOTORS CORP.
  3. Remove the throttle body and gasket. Refer to Throttle Body Assembly Replacement .
  4. Remove the supercharger inlet pressure (SCIP) sensor.
  5. Disconnect the vacuum brake booster hose.
  6. Remove the intercooler fill neck bracket bolts.
  7. Remove the vacuum line from the supercharger.
    8. Fig 3: View Of Supercharger
    GM1339285Courtesy of GENERAL MOTORS CORP.
  8. Remove the supercharger. Remove the gasket if damaged.
scientia non olet · About LEMON Manuals