LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Powertrain Mount Balance - Lower Mount

Powertrain Mount Balance - Lower Mount

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Front Transmission Mount Through Bolt
    GM1376073Courtesy of GENERAL MOTORS CORP.
  2. Loosen the front transmission mount through bolt. Do not remove.
    3. Fig 2: View Of Rear Transaxle Mount Through Bolt
    GM851620Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear transmission mount through bolt. Do not remove.
  4. Shake the powertrain vigorously from front to rear and allow powertrain to settle.
    5. NOTE: Refer to Fastener Notice .
  5. Tighten the rear transmission mount through bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft).

    6. Fig 3: View Of Front Transmission Mount Through Bolt
    GM1376073Courtesy of GENERAL MOTORS CORP.
  6. Tighten the front transmission mount through bolt.

    Tighten:  Tighten the bolt to 100 N.m (74 lb ft).

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals