LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 677 (Engine Mechanical - 2.0L (LSJ)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator Tube
    GM1339176Courtesy of GENERAL MOTORS CORP.
  1. Install the oil level indicator tube seal.
  2. Install the oil level indicator tube.
  3. Clip the upper electrical wiring harness to the oil level indicator tube.
    4. NOTE: Refer to Fastener Notice .
  4. Install the oil level indicator tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 10 N.m (89 lb in).

  5. Raise the vehicle.
  6. Clip the lower wiring harness.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals